Electronics Forum | Tue Dec 01 10:52:36 EST 1998 | Dave F
| | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect solder joint quali
Electronics Forum | Mon May 26 07:52:06 EDT 2008 | kenshiikeda
Hi mates, I encounter a problem on PCB after going thru the LeadFree Solder Wave. It shows so much dirt or dross on the PCB surface. I have attached the picture for more details. I have tried to scope out suspected solder dross and oxidedized solde
Electronics Forum | Mon Jun 18 01:09:03 EDT 2001 | Dean Stadem
Igmar, If these parts are epoxied in place, and subsequently wave soldered, I would bet you a cup of coffee that they are cracking due to the thermal shock of the wave. Typically there is a valley or dip in the temperature after the pre-heat in the w
Electronics Forum | Tue Jun 15 04:55:00 EDT 1999 | Brian Ellis
The other answers on this thread are realistic but it also depends: a) on the quality and finish of the components and PCB (including, of course, solderability) b) the flux type (I would expect lower defect rates with water-soluble than with the less
Electronics Forum | Fri Oct 30 18:08:59 EST 1998 | Dave F
| I finally got my problem figured out on the bridging, the | only thing I'm finding is that I notice some litlte solder balls on the bottom of the board. Is that normal? Is that why I'm getting bridges? Has anyone came across this problem and pass t
Electronics Forum | Mon Feb 22 19:22:40 EST 1999 | Steve Gregory
| A rash of new products here at my company have designs with multi-pin connectors 90 out-of-phase (orientation)wiht respect to wave direction, which has lead to massive bridging (shorts) problems.... | | Does anyone still use the 45 Degree Pallet
Electronics Forum | Wed Jan 27 23:29:28 EST 1999 | parag palshikar
| | i am working with the noclean process and getting white residues on the bottomside of the board probably due to the | | wave soldering flux.i am using a no-clean solder paste and a noclean wave solder flux.The boards passed the accelerated tempe
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Tue Dec 01 12:44:15 EST 1998 | Earl Moon
| | | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect solder joint
Electronics Forum | Tue Dec 01 13:53:12 EST 1998 | Brian Conner
| | | | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect solder
